Exendis Impulse Manual de usuario descargar pdf (Pagina 15)

EXENDIS B.V.

Impulse Peak Power Pack

Impulse Peak Power PackImpulse Peak Power Pack

Impulse Peak Power Pack

6. CONNECTING CONDITIONS



Output to the load (caravan mover etc.)



Power adapter



Input (car, solar panel etc.)



External switch

6.1 Connection of the output

At the output terminals (1+ and 1-) the plus and minus cables to the load (f.e. caravan

mover) can be mounted with M6 screws. (Pay attention to the polarity.) Pay attention, that

these cables must be as short as possible (to prevent voltage loss) and thick enough to

(shortly) conduct a 200A current.

If a low power load (such as lights) is connected to the output terminals as well, a fuse

with low current rating must be mounted in the positive(+) wire. If you don’t do this and a

short circuit occurs, the Impulse Peak Power Pack will not switch off and the wires can

blow and/or fire can be caused.

6.2 Connection of the pow er adapter (DC in)

At the input connection (2), the supplied 12Vdc, 1A, power adapter can be connected, so

that the Impulse Peak Power Pack can be charged from the mains. The power adapter

has to be connected to the mains socket-outlet.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Sin comentarios

Exendis Impulse Manual de usuario Pagina 15