Exendis Impulse Manual de instrucciones descargar pdf (Pagina 74)

EXENDIS B.V.

Impulse S6-S8

8. INDICATIONS

Yellow LED Green LED

Charger off (mains not

connected)





Charger just switched on and

showing the charge

characteristics



Stand-by



Charging



Full



Failure



 = Off

 = On

 = Blinking

9. FAILURE REPORT INDICATIONS

If the charger does not function (anymore), it can be restarted by pulling the mains plug

from the wall socket and putting it back in again. First of all you should however follow the

indications in the next paragraphs based on the failure report indications.

9.1 Not a single LED is lighting

• There is no mains voltage.

First check whether the plug has been fitted in the wall socket. If this has been

fitted in a wall socket it should be checked whether there is any voltage on the wall

socket. If there is no mains voltage then you should check the safety fuses in the

distribution cabinet or call a technician.

9.2 Both LED’s light

If no battery is connected, this is a stand-by condition and no failure condition.

If a battery is connected however, one of the following failure conditions may have

occurred:

• There is no battery voltage present.

Check whether the battery has correctly been connected to the charger.

If it is not connected then the connection must be restored and the charging process

should be restarted.

• The polarity of the battery connected to the charger is not correct.

Check whether the polarity of the charger corresponds with the polarity of the battery.

If it is connected correctly then you should consult your supplier/dealer.

1 2 ... 69 70 71 72 73 74 75 76

Comentarios a estos manuales

Sin comentarios

Exendis Impulse Manual de instrucciones Pagina 74

Comentarios a estos manuales